knife edge

英 [ˈnaɪf edʒ]

美 [ˈnaɪf edʒ]

adj.  形势难料的

机械

英英释义

noun

• the sharp cutting side of the blade of a knife
  Synonym:cutting edge

双语例句

• This time, United face Chelsea in a potential Barclays Premier League title-decider at Old Trafford on Saturday with the championship still on a knife edge and a run-in laden with pitfalls to come.
  这次，曼联周末就将在主场迎战切尔西。这很可能将决定本赛季联赛桂冠的归属，卫冕冠军现在的领先优势并不大。而现在又折损大将。
• His future remains on a knife edge
  他前途未卜。
• Suction outlet controlled by servo motor precision, following the knife edge automatic adjustment.
  吸风口由伺服电机精准控制，跟随边自动调整。
• The Development on Hydraulic Copying Knife Edge Grinder
  液压仿形刃口磨床之研制
• Beam quality factor M~ 2 is measured by the means of knife edge for different bending of LMA fiber and the slope efficiency is measured separately.
  采用刀口法测量了不同弯曲直径下的激光光束质量因子M~2，并对每种情况下光纤激光器的斜率效率进行了测量。
• In this paper, the parameters of the cylinder-type forage cutterhead with straight knife edge is analysed, the mathematical formulas concerned have been derived. The cutterhead ZC-1.0 is discussed as an example.
  本文对直刀刃滚刀式饲草切碎器的参数进行了分析，推导出了有关数学式，以ZC-1.0型切碎器为例作出了评论；
• The secret of successfully pressed hems is to use very little pressure so that the edge is not flattened to produce a knife edge.
  成功熨烫底边的窍门是用很小的压力，这样就不会倒伏而产生一条刃形边缘。
• Two series of fatigue crack growth rate ( FCGR) tests using three point bend specimen with different integral knife edge designs are performed. Effect of elastic modulus on the measurement of fatigue crack length using compliance technique is analyzed.
  用不同整体刀口设计的三点弯曲SE（B）试样做了两组疲劳裂纹扩展速率（FCGR）试验，分析了弹性模量在柔度法测量疲劳裂纹长度中的影响。
• Besides, in most cases the overlong distance from knife edge to the aspheric surface to be tested will decrease the precision of the knife-edge testing.
  此外，在很多情况下，刀口到待检非球面的距离很长，从而降低了刀口检验精度。
• On the basis of testing results, main cutting curves of wheat straw were given, under different cutting speeds of rotatory blade with different straw lengths, moisture centents cutting positions, different thicks knife edge, with and without shear bar.
  得出粉碎刀片在不同切割速度下，对短秆、长秆、秸秆不同切割部位、秸秆不同含水率、不同刀刃厚度、有定刀和无定刀等情况下的切断率曲线。